Elektriese kettinghysbak

Gantry construction and precautions for electric chain hoist
Electric chain hoist suppliers are generally used with cranes, gantry frames, cantilever cranes, single and double beams or KBK flexible tracks. Today I will focus on introducing you to the electric chain hoist gantry and important precautions when using it.

As the name suggests, the gantry is a portal structure composed of two columns and a beam (also called a gantry beam). Install pulleys, guide rails, warm verkoop elektriese kettinghys verskaffers te koop, safety devices, cable wind ropes, etc. on the gantry to form a complete vertical hoisting and transportation system.

Special reminder: When using the gantry, you must pay attention to the following points:
1. When installing the fabriek verskaf elektriese ketting hys verskaffers prys to the gantry, the gap between the sports car and the I-beam must be measured. The gap between the sports car wheels must be controlled within 2 mm greater than the I-beam. If the gap is too large, the vervaardiger van elektriese kettinghysverskaffers will shake, loosen, and easily fall off, causing safety accidents.
2. After the gantry is installed, a load test hoisting must be carried out. Both static load test lifting and dynamic load test lifting should be carried out. During the test hoisting process, various indicators such as the load-bearing, operation, and stability of each system must be checked.

3. Overloading is strictly prohibited during use. During the hoisting process, it must operate smoothly and cannot be twisted during hoisting.
4. There should be a dedicated person under unified command during operations, and other personnel should have a clear division of labor; a unified contact signal should be determined.
5. If there is a power outage during the hoisting operation, the goods must be put down. It is forbidden to hang them in mid-air, which may easily cause accidents.
6. Electric chain hoist suppliers supplier is strictly forbidden to stand people under the gantry during the gantry and hoisting process. This must be strictly enforced.
7. No one is allowed to stand on the simple gantry when it is running.